This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
updates:a-new-report-average-oil-consumption-has-been-added-to-leon [2015/05/25 07:51] bartek |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ==== Oil Consumption ==== | ||
- | |||
- | [{{ : | ||
- | |||
- | It is possible to monitor **oil consumption** per engine and per APU. You can input to Leon how many quarters of oil (in decimal numbers) have been used on a particular flight - a field **Oil uplift** in Journey Log has to be filled in for this purpose. | ||
- | |||
- | Based on manufacturer configuration and oil uplift entered in ' | ||
- | |||
- | * **Oil report period** | ||
- | |||
- | Go to section $$Admin$$ > $$Fleet$$, edit an aircraft and enter tab **CAM**. Insert engines numbers to make other fields editable and add appropriate data. Do the same with **APU** data. | ||
- | |||
- | In a field **Oil report period** add in full hours **window** which is used to calculate average oil consumption per engine. This value is **specified by engine manufacturer**. The oil field will set the **time window** analysis. | ||
- | |||
- | If, for example, APU is set for **50** it means that for each window time of 50 flight hours an analysis should be done. | ||
- | |||
- | The system also takes into consideration an offset value of **10 %** off the inserted amount of flight hours. So if the value input into the **Oil report period** is 50, Leon will start showing data in the report itself from 45 (10% of 50 = 5). | ||
- | |||
- | <box> IMPORTANT - the number of flight hours you input does NOT mean a series of sequential blocks of hours, it is a sliding window of hours </ | ||
- | |||
- | [{{ : | ||
- | |||
- | * **Journey Log input** | ||
- | |||
- | In $$Admin$$ > $$Operator Settings$$, tab **Flight Editing** mark a checkbox **Oil used** in section 'Show in Journey Log' | ||
- | In your Journey Log you will get a new field **Oil uplift** where you can add oil consumption data for engines and APU (see sreenshot). | ||
- | |||
- | Make sure the configuration has been done in section $$Admin$$ > $$Fleet$$ before you enter data to ' | ||
- | |||
- | * **Average oil consumption report** | ||
- | |||
- | [{{ : | ||
- | |||
- | Once data is added to the **Journey Log** and there is enough flights with journey logs filled in (with oil used data), you can view data in the section $$Reports$$ > $$Maintenance$$ > $$Average oil consumption$$. | ||
- | |||
- | You can see an example below: for first several flights there is no oil usage data because for this particular aircraft there is **Oil report period** set as **50**. That means, that there has to be a block of flights with at least 45:00 flight hours (as 10% offset off the value 50 hours is taken). | ||
- | |||
- | In the column **Oil uplift** you can see number of quarts inserted for each engine (taken from Journey Log). Then from the flight performed on 12-05-2015 you can see the **average oil consumption** based on the **block of flights** with total flight hours of at least 45. | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||